It's a single new 1TB drive partitioned:
Code: Select all
/
swap
/home
It was working fine, had rebooted several times without issue. Then yesterday I shut it down to install some more memory that I found, going from 2GB to 4GB. I hadn't made any system changes or done any updates between booting it yesterday morning and shutting it down to replace the memory.
On reboot it asked for the passphrase for sda1_crypt which it accepted, but that's as far as it gets. This is what I see
Code: Select all
Please unlock disk sda1_crypt
crptsetup: sda1_crypt set up successfuly
cryptsetup: lvm is not available
cryptsetup: lvm is not available
cryptsetup: lvm is not available
The first thing I did was put the old memory back in. I thought it unlikely to be the issue, but wanted to rule it out.
Once I was back to the the prompt I ran
Code: Select all
blkid
and
Code: Select all
cat /proc/cmdline
BOOT_IMAGE=/vmlinuz-3.16.0-4-amd64 root=/dev/mapper/sda1_crypt ro single
I'm sure I'm not the first to experience this, but I've done some googling but didn't see anyone that appeared to have the same issue.
Any suggestions for next steps?