j'ai un problème avec mon serveur sous Debian 10.10 : impossible de configurer le wol !
avec "ethtool enp2s0" j'ai pu voir que ma carte était configurée pour le wol au niveau du bios.
Supports Wake-on: pumbg
Wake-on: g
j'ai 'enabled' le wol avec la commande "ethtool -s enp2s0 wol g"
vérifié que ça avait été fait avec "cat /sys/class/net/enp2s0/power/wakeup" la réponse était "enabled"
j'ai rebooté le serveur et testé de nouveau avec "cat /sys/class/net/power/wakeup"
la réponse est systématiquement "disabled"
j'ai recommancé la procédure de nombreuses fois, pas moyens d'avoir le wol "enabled" en permanence !
si je shutdown ce serveur je suis obligé pour le rallumer d'avoir recours au personel du data center...
je ne comprends pas, le même serveur avec Debian 10.10 sur un Raid 6 formaté en Ext4 ça fonctionnait sans problèmes après une seulle procédure d'enable...
maintenant avec Debian 10.10 sur un LVM en Raid6 formaté en Ext4 ça ne fonctionne plus...
c'est pas un problmème de firewall étant donné que le firewall est éteint lorsque la machine l'est aussi.... et le wol est dabort géré par la carte eth, alors quoi ?
Quelqu'un peut m'aider ???
Merci d'avance,
Jeff
I have a problem with my server under Debian 10.10: cannot configure the wol!
with "ethtool enp2s0" I could see that my card was configured for the wol at the bios level.
Supports Wake-on: pumbg
Wake-on: g
I 'enabled' the wol with the command "ethtool -s enp2s0 wol g"
checked that it had been done with "cat / sys / class / net / enp2s0 / power / wakeup "the answer was" enabled "
I rebooted the server and tested again with" cat / sys / class / net / power / wakeup "
the answer is always" disabled "
I restarted the procedure many times, not means to have the wol "enabled" permanently!
if I shutdown this server I have to turn it on again to use the data center staff ...
I do not understand, the same server with Debian 10.10 on a Raid 6 formatted in Ext4 it worked without problems after only one procedure of 'enable ...
now with Debian 10.10 on an LVM in Raid6 formatted in Ext4 it no longer works ...
it's not a firewall problem given that the firewall is off when the machine is also off .... and the wol is dabort managed by the eth card, so what?
Someone can help me ???
Thanks in advance,
Jeff