I just installed Debian and after installation I had to install the wireless firmware. The wireless seems working normally but when I run a proxy app, I get this error:
Code: Select all
enable_ipv6(): no IPv6 enabled interfaces
resolv.conf contains these nameservers: 192.168.1.1
Code: Select all
enp8s0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 8c:16:45:e9:35:2a txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 406 bytes 34040 (33.2 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 406 bytes 34040 (33.2 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wlp7s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1280
inet 192.168.2.102 netmask 255.255.255.0 broadcast 192.168.2.255
inet6 fe80::f277:3d90:86d3:2f6 prefixlen 64 scopeid 0x20<link>
ether d8:9c:67:86:38:79 txqueuelen 1000 (Ethernet)
RX packets 5988 bytes 2948159 (2.8 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 5833 bytes 845545 (825.7 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Code: Select all
source /etc/network/interfaces.d/*
# The loopback network interface
auto lo
iface lo inet loopback