I'm facing an issue where my firmware RAID 5 setup using an Intel C600/X79 series SATA RAID Controller isn't recognized correctly by Debian GNU/Linux 12 (Bookworm). Despite configuring RAID 5 in BIOS, Debian sees my six 4TB disks as separate entities (sda to sdf) rather than a single RAID unit.
lsblk output :
Code: Select all
NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINTS
sda 8:0 0 3.6T 0 disk
sdb 8:16 0 3.6T 0 disk
sdc 8:32 0 3.6T 0 disk
sdd 8:48 0 3.6T 0 disk
sde 8:64 0 3.6T 0 disk
sdf 8:80 0 3.6T 0 disk
nvme0n1 259:0 0 232.9G 0 disk
|-nvme0n1p1 259:1 0 487M 0 part /boot
|-nvme0n1p2 259:2 0 1K 0 part
`-nvme0n1p5 259:3 0 232.4G 0 part
`-nvme0n1p5_crypt 254:0 0 232.4G 0 crypt
|-domain--vg-root 254:1 0 23.3G 0 lvm /
|-domain--vg-var 254:2 0 9.3G 0 lvm /var
|-domain--vg-swap_1 254:3 0 976M 0 lvm [SWAP]
|-domain--vg-tmp 254:4 0 1.9G 0 lvm /tmp
`-domain--vg-home 254:5 0 196.9G 0 lvm /home
Motherboard: ASRock E3C226D2I, UEFI-[Legacy]: American Megatrends v: P3.30 date: 06/04/2015
CPU: Intel Xeon E3-1220L v3
RAID Controller: Intel C600/X79 series, using the ahci driver
Kernel: 6.1.0-18-amd64
Disks: 6x Seagate 4TB
I've looked into solutions, including mdadm, but it seems the ahci driver is being used instead of a specific RAID driver. I understand Debian wasn't explicitly listed among the supported OS by my motherboard, but I was hoping to find a way to make the hardware RAID recognized properly under Debian.
Any suggestions or similar experiences ?
Thank you in advance!